Header Only - DO NOT REMOVE - Extreme Networks

XOS 15.7.1.4 mvrp between BD8806 and SUMMIT X460-G2-48t-10GE4



Show first post

28 replies

Userlevel 6
Antonio,

There were actually multiple problems with that article. I have corrected the article (and renamed it something more practical):

Can a VLAN created dynamically by MVRP be renamed?

To preserve your work above, I also created another article pertaining to your issue:

VLAN not propagating across the network after enabling MVRP

Please let me know if you would like me to add or change anything.

Also, I wanted to point out that the following commands are default, you do not have to enter them:
configure mvrp tag 500 ports 2:49 registration normal
configure mvrp tag 500 ports 2:49 transmit on
configure mvrp vlan auto-creation on
configure mvrp vlan registration normal[/code]By default all MVRP enabled ports can join any VLAN and will advertise all VLANs (with a port in them :)).
Userlevel 1
Antonio,

There were actually multiple problems with that article. I have corrected the article (and renamed it something more practical):

Can a VLAN created dynamically by MVRP be renamed?

To preserve your work above, I also created another article pertaining to your issue:

VLAN not propagating across the network after enabling MVRP

Please let me know if you would like me to add or change anything.

Also, I wanted to point out that the following commands are default, you do not have to enter them:
configure mvrp tag 500 ports 2:49 registration normal
configure mvrp tag 500 ports 2:49 transmit on
configure mvrp vlan auto-creation on
configure mvrp vlan registration normal[/code]By default all MVRP enabled ports can join any VLAN and will advertise all VLANs (with a port in them :)).

hi chad,

thanks for your prompt support.

about your article VLAN not propagating across the network after enabling MVRP, well done.

I guess that the command on switch B:

configure vlan test add port 3[/code]
should be

configure vlan test add port 3 tagged[/code]
The obvious reason is that, as you mentioned in that article
"MVRP is enabled on port 2 of each switch and added to the default VLAN untagged".
So, if I try to add port 3 untagged EXOS complains.

Thank you

[I tried to send this feedback on GTAC Knowledge as Ryan previously suggested, but having already given a positive feedback on the article, I cannot write comments anymore]
--
antonio
Userlevel 6
Antonio,

There were actually multiple problems with that article. I have corrected the article (and renamed it something more practical):

Can a VLAN created dynamically by MVRP be renamed?

To preserve your work above, I also created another article pertaining to your issue:

VLAN not propagating across the network after enabling MVRP

Please let me know if you would like me to add or change anything.

Also, I wanted to point out that the following commands are default, you do not have to enter them:
configure mvrp tag 500 ports 2:49 registration normal
configure mvrp tag 500 ports 2:49 transmit on
configure mvrp vlan auto-creation on
configure mvrp vlan registration normal[/code]By default all MVRP enabled ports can join any VLAN and will advertise all VLANs (with a port in them :)).

Antonio,

Port 3 was not added to VLAN default in my example, so this command would work. However, I added "tagged" to the command in the article anyways.

Thanks for all your input.

As for the article feedback, yes this is currently a limitation of GTACKnowledge. You cannot comment on positive feedback.

Reply