BDXA Temp monitoring

  • 10 March 2017
  • 2 replies
  • 895 views

I need an OID to monitoring via SNMP different BDXA-10G48T modules on the same switch. Any help?

2 replies

Hi Drew...

We can currently monitor the temperature of a sw, but we had a fault due to a module in specific BDXA-10G48T, whose temperature range was very high and different from that reported by SW and caused malfunction. The question is whether there is a MIB that specifically reports this value to my monitoring tool?

regards
Userlevel 7
Hello Francisco,
Did you receive an answer to your question from another source yet? What specifically do you want to monitor on these modules?

Reply