Does anyone have a script to get the port where access point based is connected based in your MAC OUI (MAC OUI previously defined) and then configure this port to pass one or more vlans em tagged mode?

  • 16 November 2020
  • 1 reply

It is possible to create a routine using Python script or otherwise on the switch, where the script detect the vendors mac address (Extreme Access Point as example) on the FDB checking every 30 minutes and then, if a MAC OUI = X is found, this script configure this port to pass two or more vlans in tagged mode.



Edson Moura


Best answer by StephanH 16 November 2020, 07:49

View original

1 reply

Userlevel 6

Hello Edson,


this should be possible with a UPM script.

Check the XOS manual for “Universal Port” and have a look to that article:

and that: