I’m very new to XMC and I’ve seen on this board that it is possible to disable/enable ports at certain times. I’m interested in doing this for our DR but I don’t know how to. I’ve looked on XMC and can’t see anything obvious, I’m assuming you essentially run a script at scheduled times? How do you schedule a script on XMC?
Can anyone confirm and if a script already exists on the forum for the enable/disable point me in the right direction?
Best answer by Christopher Thompson
My unofficial answer(and it pains me to say it) has been using Edge(still painful to type) and enable dark mode like below with the “flags” method:
I haven’t personally seen any “odd” behavior.