How to configure voice and data vlan on the same 200 series switch


Userlevel 1
Hi Team,

we have 2 VLANs for voice and data, we need to access both VLAN on the same 200 series switch port.

what are the procedures to configure the switch port?

8 replies

Hello Niyas,
you need to untagg the ports for data vlan, and tagg the ports for voice vlan.
the voice end point needs to send the vlan id. If you use the 210 serie, then you need a additional L3 device (firewall, router) to route between the 2 vlan's, if you use the 220 serie, this is a L3 switch and can route between the two vlan's.
Userlevel 1
Ignace Vyncke wrote:

Hello Niyas,
you need to untagg the ports for data vlan, and tagg the ports for voice vlan.
the voice end point needs to send the vlan id. If you use the 210 serie, then you need a additional L3 device (firewall, router) to route between the 2 vlan's, if you use the 220 serie, this is a L3 switch and can route between the two vlan's.

(Extreme 220) (Interface 1/0/2)#voice vlan 110
(Extreme 220) (Interface 1/0/2)#switchport mode access
(Interface 1/0/2)#switchport access vlan 10
(Interface 1/0/2)#switchport trunk native vlan 10
(Interface 1/0/2)#switchport trunk allowed vlan 110
(Interface 1/0/2)#exit

This is correct or not?
Ignace Vyncke wrote:

Hello Niyas,
you need to untagg the ports for data vlan, and tagg the ports for voice vlan.
the voice end point needs to send the vlan id. If you use the 210 serie, then you need a additional L3 device (firewall, router) to route between the 2 vlan's, if you use the 220 serie, this is a L3 switch and can route between the two vlan's.

Can anyone share any configuration of most services in a switchn extreme 210 and 220 series? These are not XOS, there is no clear documentation of this series of equipment. Thank you[/code]
Userlevel 7
Documentation can be found here:
https://extremeportal.force.com/ExtrProductDetail?id=01t340000042wkAAAQ
http://documentation.extremenetworks.com/200_hardware/index.html
http://documentation.extremenetworks.com/200_setup/index.html
http://documentation.extremenetworks.com/200_admin/
http://documentation.extremenetworks.com/200_commands/

i.e.

configure

interface 1/0/1-1/0/14

switchport mode trunk

switchport trunk native vlan 100

switchport trunk allowed vlan 200
Userlevel 1
Thanks for your updates
Userlevel 1
1. Enter config


(Extreme 220) #config


2. Enter port config mode
(Extreme 220) (Config)#interface 1/0/2

3. Configure the following
(Extreme 220) (Interface 1/0/2)#voice vlan 110
(Extreme 220) (Interface 1/0/2)#switchport mode access
(Interface 1/0/2)#switchport access vlan 10
(Interface 1/0/2)#switchport trunk native vlan 10
(Interface 1/0/2)#switchport trunk allowed vlan 110
(Interface 1/0/2)#exit

This is correct or not?
Userlevel 7
no need for "switchport access vlan 10" because you configure it with "switchport trunk native vlan 10"
Userlevel 1
Hi Ronald

I have already configured, need to remove Switchport access VLAN 10?

Reply