Hello Community,
i have tried several times to update one of my many AP130. Everything seems fine, the device does a reboot, but then it shows the same old Firmware as before. All other AP’s (i have meanwhile over 200) could be updated without problems.
Any suggestions to solve the Problem? I have the device at my workplace with the ability to CLI-Access.
Greetings
Steffen Blum
Best answer by s.blum1
Ok, after many fails while upgrade to the newest Firmware (10.0r10a) or the same as actually installed (10.0r9b) I have tried today another way. I choosed to install an older version (10.0r8a) an after that went back to the newest and that did it. Reproduced on the other two AP130 with the same problems and all of theme are fine now.
Thanks a lot for your help
Do i have to close the thread?