Header Only - DO NOT REMOVE - Extreme Networks
Question

AP's with link problems


Userlevel 4
In our dashboard I noticed that ther where AP's with link problems. However there are no problems. How can I clear this messages ?

5 replies

Userlevel 7
Hi Johan,

you'll get a "link problem" error if the port isn't running 1G so i.e. if you've the APs connected to a 100M only switch or if autosensing isn't working.

-Ron
Userlevel 4
Hi Johan,

What is the firmware version on the controller? Please check the below KB article,

https://gtacknowledge.extremenetworks.com/articles/Solution/AP-s-are-listed-in-the-AP-s-with-uplink-...

Regards,
Nathiya M
Userlevel 4
Nathiya Munuswamy wrote:

Hi Johan,

What is the firmware version on the controller? Please check the below KB article,

https://gtacknowledge.extremenetworks.com/articles/Solution/AP-s-are-listed-in-the-AP-s-with-uplink-...

Regards,
Nathiya M

firmware version is 10.31.03.001. AP's are connected to a 100 Mb port.
Userlevel 4
Ron wrote:

Hi Johan,

you'll get a "link problem" error if the port isn't running 1G so i.e. if you've the APs connected to a 100M only switch or if autosensing isn't working.

-Ron

Ap's are connected to a 100 Mb port. Autosensing is working
Userlevel 7
OK then it's normal if the APs are connected via a 100Mb ports.

I'm not aware of any way to clear that alarm.

Reply