Question

Enable availibilty at C5210 and have problem to view atatus

  • 10 September 2017
  • 2 replies
  • 156 views

I have two C5210 wireless controller and Enable Availibility and some AP status is at EWC1 is inactive and at other EWC (EWC2) is Active.
the other Problem is I cannot Reboot AP by Controller.
please help me to solve this problems.

thanks

2 replies

thanks
Userlevel 7
I strongly suggest that you attend the official training to learn more about the controller functions...

http://www.extremenetworks.com/education/courses/ESE-HI-1/

Let's assume you run v10 as you didn't mentioned the installed software version.
On controller#2 in the GUI > AP > APs > Foreign > select all > Actions > Release

That should terminate the tunnel from controller#2 to the APs and the APs should open a tunnel to controller#1

Cheers,
Ron

Reply