Firmware Version 10.21


Userlevel 5
Hi all

I have been following the launch of the new 3912 and 3916 AP's.
I am very excited about the new models.

I see the new AP's is launched with the new Ver 10.21 firmware.
Can we get access to the new firmware?
Under my downloads I only have access to ver 10.11...
If not do you have release notes available?

Thx

8 replies

Hello Andre
FW 10.21 is not yet released. Not even internal.
You will see an update on this if you are registered to the WLAN info or just contact our GTAC and ask 4 early adoption.
Alex
Userlevel 4
Alex wrote:

Hello Andre
FW 10.21 is not yet released. Not even internal.
You will see an update on this if you are registered to the WLAN info or just contact our GTAC and ask 4 early adoption.
Alex

I need early access too and an AP3912i for use during a large site survey. I will open a GTAC case/request.
Userlevel 7
I wonder whether the dimensions in the datasheet are correct because in the pictures it doens't look like that the AP3912 has equal hight/lenght.

Dimensions per datasheet = 8.46” x 8.46” x 2.2” (21.5 x 21.5 x 5.6 cm)

Regarding the software, I think it will take some more weeks till the AP is shipped to the end customer.
Userlevel 4
Ron wrote:

I wonder whether the dimensions in the datasheet are correct because in the pictures it doens't look like that the AP3912 has equal hight/lenght.

Dimensions per datasheet = 8.46” x 8.46” x 2.2” (21.5 x 21.5 x 5.6 cm)

Regarding the software, I think it will take some more weeks till the AP is shipped to the end customer.

Hello Ronald,

this Twitter post in the included link show some picture of the new AP:

https://twitter.com/Aliyoussef_/status/793211794093404160
Userlevel 4
It should be 18.5 x 12.5 x 2.5 cm .
I will check if this get changed otherwise I will forward this for change.

Umut Aydin
Userlevel 7
Umut Aydin wrote:

It should be 18.5 x 12.5 x 2.5 cm .
I will check if this get changed otherwise I will forward this for change.

Umut Aydin

Thx
Userlevel 5
So a question regarding the new AP3912.
Will the Ethernet ports support B@HWC controller?
It will be a nice feature to be able to tunnel the ethernet connected devices to the controller.

Thx
Userlevel 5
Answering my own question, but Yes the Ethernet ports will allow Bridge@HWC.

Thx

Reply