Header Only - DO NOT REMOVE - Extreme Networks

how to active access point ws-ap3805i connect to wireless controller c35


how to active access point ws-ap3805i connect to wireless controller c35

5 replies

Userlevel 3
is that ap connected over WAN/VPN? is a ping from ap to ewc possible?
if yes check AP -> Static configuration -> Tunnel MTU and lower that value eg 1300 instead of 1500
Anton Sax wrote:

is that ap connected over WAN/VPN? is a ping from ap to ewc possible?
if yes check AP -> Static configuration -> Tunnel MTU and lower that value eg 1300 instead of 1500

hi ,
No ping AP it not possible
and I change MTU but no result.
Userlevel 7
Hi, the screenshot shows an AP3825i and not an AP3805i.

Because you don't provide any details about the steps you've performed or i.e. a network diagram I don't see any chance to help you..... i.e. the AP in the screenshot could be manualy added or it was discovered which is a big difference.

The best advice I'd give you is to pay a Extreme Partner to install/configure it for you and also give a brief workshop so you'd perform configuration in the future by yourself.

BR,
Ron
Userlevel 4
Hi,

check out your license..I hope it's not in a DEMO mode?
Need enter a eval license or get a valid license.

Regards
Umut Aydin
Userlevel 4
Hi,

if AP3805 in question ..seee please this one.
https://gtacknowledge.extremenetworks.com/articles/Q_A/Minimum-firmware-version-for-WS-AP3805

Rgds
Umut Aydin

Reply