NetSight -> Wireless -> can't see threats


Userlevel 6
Hello!

Have C35 controller, 1 AP as data AP, 2 AP as Radar AP.
In Netsight I can see all data from wireless devices except Threats.

Any ideas?

Thank you!

9 replies

Userlevel 5
In radar interface on the controller GUI can you see the threats listed?
Userlevel 6
Most interesting, that only now I see that my Radar AP is periodically reboot with reason "AccessPoint Rebooting due to: Received Standy Request from Wireless Controller"

This happend after upgrade C35 to 09.21.05.0007 soft.

Ideas?

Thank you!

Userlevel 7
Have your access points upgraded to the latest code to match the controller version?
Userlevel 7
Doug wrote:

Have your access points upgraded to the latest code to match the controller version?

Also, what model access point is being used as a Radar AP (Guardian) or is it just doing in-service scanning?
Userlevel 6
Doug wrote:

Have your access points upgraded to the latest code to match the controller version?

Yes.
In AP tab I can see that all AP's have 09.21.05.0007 too.

Thank you!
Userlevel 6
Doug wrote:

Have your access points upgraded to the latest code to match the controller version?

3805i
Guardian.
Before soft upgrade was working as Guardian normally.
Userlevel 6
Doug wrote:

Have your access points upgraded to the latest code to match the controller version?

Change AP to In-SErvice.
AP reboot due configuration change, and after 3 minutes again "AccessPoint Rebooting due to: Received Standy Request from Wireless Controller"
Userlevel 7
Doug wrote:

Have your access points upgraded to the latest code to match the controller version?

hmmm... I've just added one in my lab, no issues. I would need to see the ap tracelog package to understand what the ap is doing.
Userlevel 7

Reply