Remote Port Required


Userlevel 2
I'm reconfiguring a wireless network and have run into an issue. Currently the network is set up as a /16 subnet and I'm reducing it to a /22. I changed the gateway device's mask to /22, but when I try to change the controller's mask it tells me that "The Remote Port is Required". What am I missing here?


3 replies

Userlevel 2
Well... It appears that the problem was the Synchronize checkbox. I had to uncheck it since this topology does not exist on my other controller.
Userlevel 5
Terren Crider wrote:

Well... It appears that the problem was the Synchronize checkbox. I had to uncheck it since this topology does not exist on my other controller.

That's funny. I had this same issue. But when I saw you post this error message I was racking my brain about what I did to get that message.
Userlevel 7
Terren Crider wrote:

Well... It appears that the problem was the Synchronize checkbox. I had to uncheck it since this topology does not exist on my other controller.

Reference: https://gtacknowledge.extremenetworks.com/articles/Solution/ExtremeWireless-Error-when-saving-a-port...

Reply