cluster config update rejected


Userlevel 2
Hello
I have a cluster with 2 rfs 6000. Since yesterday, this event appears:
Err: cluster config update rejected - master does not accept full config.
And any configuration made in the active rfs is not replicated in the standby rfs

6 replies

Userlevel 3
Please check how your CLUSTER was formed. Are you forming it with both I/P and VLAN. If so, remove the CLUSTER VLAN.

If not the issue, you will need to submit a case .
Userlevel 2
Andrew Holden wrote:

Please check how your CLUSTER was formed. Are you forming it with both I/P and VLAN. If so, remove the CLUSTER VLAN.

If not the issue, you will need to submit a case .

Hello Andy
Thanks for the reply.
The cluster was already formed. And the vlan cluster is already disabled.
Userlevel 3
Hi Jose,

Please reference the following KCS article on WiNG cluster configuration.

How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above
Userlevel 4
Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem.
Userlevel 2
Timo wrote:

Hi,
do you have configured different priority? If you don't configure this and have new configuration on booth sides, that can be the problem.

Hi Timo
The priorities are configured with different values in the two rfs.
The rfs and the cluster were working well for a long time until the restart that was made yesterday.

the show cluster member command shows the two rfs and the show cluster status command shows one rfs in active and another in stanby in the cluster
Userlevel 2
Solved
Turning off and starting the controllers in order, first the active controller and then the standby controller, the cluster has been configured ok and the error has disappeared. The simplest solution at the end is the most effective.
Thanks everyone
Regards.

Reply