Configure VRRP Protocol


Userlevel 1
Hello community. How to configure VRRP between a SW BD8810 and WM3700?

4 replies

Userlevel 6
Hi!

You mean - BD and WM will be two VRRP instances with 1 VIP?
Userlevel 1
Hi Alex.

(1)I have two BD8810 sw interconnected and two wm connected to each SW . I have a captive portal that runs on a WM. (2)I want to configure VRRP for the Captive Portal to run in a virtual ip for redundancy.

attached example

Userlevel 7
Hi Daniel,

You should be able to create the VRRP instance on the WMs with the commands below.
vrrp interface vlan vrrp ip [/code]Since this will be the same on both WMs, you should be able to put this config into the WM3700 profile.

-Brandon
Userlevel 7
Brandon Clay wrote:

Hi Daniel,

You should be able to create the VRRP instance on the WMs with the commands below.
vrrp interface vlan vrrp ip [/code]Since this will be the same on both WMs, you should be able to put this config into the WM3700 profile.

-Brandon

I created a GTAC Knowledge article for this as well.

Reply