Header Only - DO NOT REMOVE - Extreme Networks

Monitor AP4610 values via SNMP?


Hello

How can I monitor the following values of an AP4610 Extreme access point via SNMP?
- Number of devices currently connected
- Traffic on radio interfaces (Mbit)
- Mode and speed of the 2.4 ghz and 5 ghz radio interface

Many thanks in advance!

Lukas

2 replies

Userlevel 5
Lukas,

The following OIDs may help:

-- 1.3.6.1.4.1.1916.2.131.50.1.4.3.2.11.1.1.12
"Traffic Utilization Index

Measures the efficiency the medium under consideration
is used. It is the percentage of the current data throughput
over the theoretical data rate limit, which is derived
the current maximum physical rate configured over the medium
based on past empirical data. This index could assist end user
in site planning and expansion. The numerical value might be
further classified as:
-1: no data available ( e.g. radio is not in wlan operation
mode )
0-20 : very low utilization
20-40: low utilization
40-60: moderate utilization
60 and above: high utilization

-- 1.3.6.1.4.1.1916.2.131.50.1.3.33.2.1.5
"The rf-mode of operation for the radio.
Values:
2.4GHz-wlan
5GHz-wlan
sensor


Let me know the results.

Thanks!
Userlevel 4
Hi Lukas,

The SNMP tool which we talking about is Netsight or ridgeline ?

Thanks,
Suresh.B

Reply