Header Only - DO NOT REMOVE - Extreme Networks

Remove Wing 7522 from Virtual Controller to make it stand alone?

  • 28 January 2019
  • 1 reply

I have a Wing 7522 access point that I would like to make a stand alone device. How do I remove it from a 7522e virtual controller? I have reset the 7522 to factory defaults, but it still goes back on the virtual controller.

1 reply

Userlevel 5
For stand-alone mode, best to access the AP CLI (Command line interface) and perform the following:

enable [enter]
self [enter]
no mint mlcp ip [enter]
no mint mlcp vlan [enter]
com write [enter]