Solved

WiNG Express Mesh Connex

  • 20 February 2019
  • 4 replies
  • 764 views

hello hub

i have a problem with mesh connex in wing with express gui
two ap7522 and i will always get errors, i dont know how to configure this

could you please send to me a document, video or post a link with information about how configure mesh connex in wing express gui ?

mesh connex is only with same ap models possible?

as always thank you for your time and support luke
icon

Best answer by Christoph S. 20 February 2019, 16:32

Hello Luke,

I've attached the instructions for your perusal.

Important: If setting those up in the lab make sure that they are at least 2 feet away from each other and reduce the radio power to 1. Once you have the units talking to each other and before deploying them in the field, set the radio power to whatever you need it to be.

Thank you,

Chris
View original

4 replies

Userlevel 5
Hello Luke,

I've attached the instructions for your perusal.

Important: If setting those up in the lab make sure that they are at least 2 feet away from each other and reduce the radio power to 1. Once you have the units talking to each other and before deploying them in the field, set the radio power to whatever you need it to be.

Thank you,

Chris
Hi Chris,

Thank you so much for your speedy assistance, your tech forum/support is truly appreciated and something that other companies could not touch on their best day 😉

one other question to mesh
i have a isolated solution, with one ap7562 and i will mesh to a other point...this also must be a ap7562?
Userlevel 5
Hello Luke,

You should be able to mesh heterogeneous APs as long both support meshconnex and are on the same firmware version. It's recommended and always easier if both are the same model though.

Thank you,

Chris
Hi, is it possible to use 5GHz for my SSIDs when i am Enabling mesh connex on 5 Ghz Band?
I ask because i was not able to configure Mesh Connex until i free up the 5 Ghz-Band.

Thanks

Reply