AP 6532 Led Indicators

  • 4 December 2017
  • 6 replies
  • 2080 views
L
Hi, I have 2 6532 APps that were working without a problem, now they are not responding, i reboot them and they doesn't come up, the LED Indicators are Solid Green and never change this State.

¿What can i do?, they dont have an console port.

6 replies

E
Userlevel 2
You can enter via CLI to the Virtual Controller and send the following information:

show boot

show adoption history

show adoption status


B
Rank
Userlevel 5
Hello Leonardo,

See an article here:

What does LED blinking means on AP650?

As per the description you might be experiencing bootup or memory corruption issues.
Please consider raising a support case or RMA to get your APs replaced.

Regards,
OndrejHello Leonardo,

Here is one article about how to submit an RMA case.

Submit an RMA Case on the Extreme Portal
https://gtacknowledge.extremenetworks.com/articles/How_To/Submit-RMA-via-New-Support-Portal

Regards,
Bin
Ondrej Lepa
Rank
Userlevel 6
Hello Leonardo,

See an article here:

What does LED blinking means on AP650?

As per the description you might be experiencing bootup or memory corruption issues.
Please consider raising a support case or RMA to get your APs replaced.

Regards,
Ondrej
JESUS REYES DIAZ
you can see the AP with apdiscover tool?
Ing. Francisco Reyes
L
Hi Edmundo, thanks for your response.

The leds are always on, they never change,

Its Strange because it was working, and suddenly 2 AP stoped respoding ping and then a third, when rebooted the Leds dont change.

I have 4 AP 6532 and one of them is the virtual controller of all of them, at first i thought it was an Hardware issue, now i think it could be and problem with the virtual controller.

I dont have a lot of experience with this AP with a virtual controller among them.

E
Userlevel 2
Hi Leonardo

This status indicates that the equipment is in the process of system booting
Did you try updating the Firmware?
Do you have controller?

Reply