We have one VX-9000 controller which is having around 800 access points. in this scenario there is no standby controller now we are going to configure the standby controller with current setup.
If active controller goes down automatically standby should take care of active role.
How does AP know standby controller IP and how do we setup this configuration.
Kindly help us to do with this current scenario
Userlevel 4
- Extreme Employee
- 72 replies
-
22 April 2019
Hi
The following knowledge article below should help with your query.
How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above
The following knowledge article below should help with your query.
How to configure a cluster in ExtremeWiNG Controllers on WiNG5.4 and above
Reply
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.