Header Only - DO NOT REMOVE - Extreme Networks

DFE with 'GBIC indicated TX Fault.' error message


Userlevel 3
Article ID: 7352

Products
DFE

Symptoms
Error message
"GBIC indicated TX Fault."

Cause
Examples of this repeating message are shown below, as extracted using a FlexView (5497):

code:
1001.1 2006-01-23,03:16:12.0 Syslog Message

<
code:
3
>
code:
System[1]GBIC 5 indicated TX Fault. 04.05.07 0

code:
. . .

code:
1089.1 2006-01-23,03:17:38.0 Syslog Message

<
code:
3
>
code:
System[1]GBIC 5 indicated TX Fault. 04.05.07 0


This example indicates transmit failure of GBIC instance 5 on the slot 1 blade or installed 7G-6MGBIC(-A). The problem could be due to that GBIC, its peer port, or the cable connecting them. Troubleshoot to the defective component.

Note that for Enterasys analysis purposes the recommended extraction method is via ATGTools, as explained in 5101.

Solution
Troubleshoot to the defective component.
Contact Enterasys Networks Technical Services for additional assistance, as necessary.

See also: 10385.

0 replies

Be the first to reply!

Reply