Extreme AP Configuration

  • 21 October 2014
  • 8 replies
  • 2676 views

I am trying to setup an AP 3825i to perform a site survey. I am trying to access the CLI to set the config, however, I apparently do not have the default login credentials (admin/admin123 don't work). Does anyone have the correct default login credentials?

8 replies

ok got it
thank u
Userlevel 7
You can configure "Maintain client sessions in event of poll failure" via the controller GUI.
ok, we can configure ap standalone by controller....right
Userlevel 7
Yes&No.

There is no standalone mode but as mentioned above you'd configure a controller AP to act like a standalone AP.

That is possible with all controller APs also with the AP3805i.
hi

Is this possible to configure AP 3805i in standalone?
If it possible please let me know....
Userlevel 5
ah...ok. thought the AP did have standalone mode. will set up per advised recommendation.

thanks.
Shane,

The following KB Article would help you to configure an AP for site survey:-

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-thin-access-point...

ah...ok. thought the AP did have standalone mode. will set up per advised recommendation.

thanks.
Userlevel 7
admin/new2day but even that will not solve the problem as the AP has no standalone mode

The only way to do it is... short version....
- connect AP to WLAN appliance
- setup a wlan service/topology/VNS that is bridge@AP untagged
- set the antenna. static channel, tx power and all the other radio settings
- in "AP properities" in the advanced section select "Maintain client sessions in event of poll failure" and "Restart service in the absence of controller"

Now you'd unplug the AP and use it for a site survey.

Reply