tunel entre CWE y AP3610 remoto a través de internet , es posible?

  • 27 February 2016
  • 11 replies
  • 234 views

Hola, tengo un proyecto donde se propone tener una CWE en un sitio fijo y tener el control de alrededor de 10 AP en oficinas remotas sin la utilización de hardware VPN, el enlace entre CWE y AP es a través de Internet, es posible esta configuración sin la utilización de VPN?.

11 replies

El reenvío de puertos y el establecimiento de un defecto en la configuración estáticaHWC.

El reenvío de puertos y el establecimiento de un defecto en la configuración estáticaHWC.

Tan yo u, necesito algo de información, alguna alternativa o manual para este tipo de instalación?
Userlevel 7
Reference: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-Wireless-Solution...
Reference: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-Wireless-Solution...


T ank you, I need more información about it, can you help me?, or alternative about it, I can read in Thor Link that I should configurate public IP in the controller , where can I get more information about is or configuration guide.
Reference: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-Wireless-Solution...


If the guide doesn't make sense, maybe contact Extreme for professional services or pay a contractor to help out. Setting up an entire wireless controller would be tricky communicating through the hub.
Reference: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-Wireless-Solution...


But... You are going to have to configure your L2 interfaces. Setup an interface with a public IP and allow the appropriate ports to be open. Use the static config option in the AP config to point the AP to the public IP address of the controller. Assuming everything is setup right, the AP will establish it's secure tunnel. It's quite easy to do, however, I am not 100% sure it is the recommended way. Currently, I tunnel everything through an ASA IPSEC tunnel for remote APs.
Reference: https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-setup-an-IdentiFi-Wireless-Solution...


hello, thank you , I tray mount a laboratory , but this is my problem now.
https://community.extremenetworks.com/extreme/topics/ap-remote-office-offline-in-the-cwe-no-tunel?rf...
Userlevel 7
Take a look into this post....
https://community.extremenetworks.com/extreme/topics/bridged-ap-connected-client-cannot-obtain-dhcp-...

If that doesn't make sense I'd recommend what Jermey suggested ...
" contact Extreme for professional services or pay a contractor to help out"
Take a look into this post....
https://community.extremenetworks.com/extreme/topics/bridged-ap-connected-client-cannot-obtain-dhcp-...

If that doesn't make sense I'd recommend what Jermey suggested ...
" contact Extreme for professional services or pay a contractor to help out"
thank you, I trayed mount a laboratory and my problem this is now , https://community.extremenetworks.com/extreme/topics/ap-remote-office-offline-in-the-cwe-no-tunel?rf...
Userlevel 7
This thread may also be helpful: https://community.extremenetworks.com/extreme/topics/aps-on-wan-side-of-firewall-dont-upgrade
This thread may also be helpful: https://community.extremenetworks.com/extreme/topics/aps-on-wan-side-of-firewall-dont-upgrade

thank you, I trayed mount a laboratory and my problem this is now , https://community.extremenetworks.com/extreme/topics/ap-remote-office-offline-in-the-cwe-no-tunel?rf...

Reply