WS-AP3705i Console Port

  • 6 March 2015
  • 5 replies
  • 2078 views

We want to use AP3705i console port.
Can we configuration from console port of AP3705i? (IP, gateway, etc.)
to tell us ;
AP console port pin assignment , terminal setting

Regards,


5 replies

Thank you very much, I'll try the command.

Userlevel 6
Is there a way to confirm configuraration a "show configuration" command or something like that?
There's "cget config" which is fairly comprehensible.
Is there a way to confirm configuraration a "show configuration" command or something like that?
Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave

The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.

Thank you for reply.

We were able to confirm that it can be set from the console port.

However, there was the discovery of 2 points.

1, console cable, in the Cisco console, was not a Enterasys console.
2, It was required first to [cset dhcpc disable] command

** We have tested with firmware version "08.32.08.0002".

Regards,

Userlevel 7
Hi, you'd set the following parameter via the console port to allow the AP to connect to the controller if you don't use an DHCP server...
- IP = cset ipaddr x.x.x.x
- subnetmask = cset ipmask x.x.x.x
- gateway = cset gateway x.x.x.x
- set controller IP = cset authip 1 x.x.x.x
to apply and save use..
- capply
- csave

The baudrate is 115200 - just use a the same console cable as you'd use for a router/switch.

Reply