What's the Extremeware and XOS command equivalent of cisco's show int | i proto|Last in

  • 15 November 2017
  • 5 replies
  • 473 views

Userlevel 1
I need to know how many days has a port been unused via console/telnet, in extremeware (and XOS) with epicenter SW you are able to track but I want to know is there is a CLI equivalent to CISCO show int | i proto|Last in

Thanks

5 replies

Userlevel 7
I think this will get what you want:

X440G2-12t-10G4.18 # show port info detail | include Port:|Link\sState:|Link\sUps:|Link\sDowns: Port: 1
Link State: Active, 1Gbps, full-duplex
Link Ups: 1 Last: Thu Aug 03 16:59:29 2017
Link Downs: 0 Last: --
Port: 2
Link State: Ready
Link Ups: 0 Last: --
Link Downs: 0 Last: --[/code]
Userlevel 6
Show port info detail will show you the last link up but resets when the stack reboots.
Userlevel 7
In EXOS, you can see the last up/down dates at the top of the
code:
show port X info detail
command:
# show port 12 info det
Port: 12
Virtual-router: VR-Default
Type: UTP
Random Early drop: Unsupported
Admin state: Enabled with auto-speed sensing auto-duplex
Link State: Ready
Link Ups: 2 Last: Mon Oct 30 05:32:11 2017
Link Downs: 2 Last: Tue Nov 14 10:26:57 2017
....[/code]
EDIT: Brandon's answer above is better than mine.
Userlevel 1
Thanks for your replies... and do you know if there's a way to know on Extremeware 7.8e.4.1 (one of our legacy switches.. )?

Gracias
Userlevel 7
Thanks for your replies... and do you know if there's a way to know on Extremeware 7.8e.4.1 (one of our legacy switches.. )?

Gracias
It looks like the same command on eware gives a counter, but not timestamps. There may be another, but there aren't any powered on in the labs to test. Here's the example from the command reference guide:
# show ports 2:6 info detail

Port 2:6:
Type: UTP
Diagnostic: passed
Random Early Drop: Disabled
Admin state: Enabled, with auto-duplex auto-speed sensing
Link state: Ready
Link counter: Up 0 time(s), Down 0 times(s)
VLAN cfg:
Default [Internal Tag=0001,Mac-Limit:Cfg=No-limit,LRN=0,BlkHole=0]
....[/code]

Reply