Can i use Extreme SFP transceiver for switch Cisco 3850 and Cisco 6807 XL???


Our customer have two switchs Cisco 3850 and Cisco 6807 XL, they are using there modules:
- 1000BASE-SX SFP transceiver module MMF 850nm DOM
- 1000BASE-T SFP
- 10GBASE-SR SFP Module

They want to buy new Extreme SFP as below to replace:

- 1000BASE-SX SFP 10 Pack, Industrial Temp
MMF 220 & 550 meters, LC connector
- 10/100/1000BASE-T SFP module, CAT5 cable 100m link, RJ45-connector for Giga Bit Ethernet SFP Port, Industrial Temp
- 10 Gigabit Ethernet SFP+ module, 850nm, MMF 26-300m link, LC connector

is it OK ? can we use Extreme transceiver for Cisco switch ?

4 replies

Userlevel 3
No. Not recommended. This is not Cisco forum. For lab environment its possible.
http://www.firewall.cx/cisco-technical-knowledgebase/cisco-switches/866-cisco-switches-3rd-party-sfp...

Cisco will err-disable your port. They have EEPROM.
Ask your customer to buy Cisco SFP, if not they will not support it.
Thanks Wong Peng Leong for your answer !
Can i use a transceiver SFP+ 1310nm 10Gb/s -8.2~0.5dBm -12.6dBm LC SM 10km Cisco for Extreme Siwtch, is this compatible?...Thanks for your help
Userlevel 7
Arturo Rodriguez wrote:

Can i use a transceiver SFP+ 1310nm 10Gb/s -8.2~0.5dBm -12.6dBm LC SM 10km Cisco for Extreme Siwtch, is this compatible?...Thanks for your help

Looks like you've asked this in a new thread: https://community.extremenetworks.com/extreme/topics/can-i-use-a-transceiver-sfp-1310nm-10gb-s-8-2-0...

Reply