Header Only - DO NOT REMOVE - Extreme Networks

GTAC Knowledge new articles June 12, 2015

  • 12 June 2015
  • 3 replies

Here are the articles that have been published this week (June 8 - June 12, 2015) in GTAC Knowledge

Friday June 12: XSR Reboots Intermittently Poor performance on the 3825i or any 38xx series access point with TKIP enabled Wireless Clients are getting disconnected before the vlan limit is reached in the SSID SNMP OID . not fetching the current temperature

Thursday June 11:
Where is the Documentation for the 800 Series Switches? C4110 shows error on screen: Enterasys C4410-1 Cannot Ping Virtual IP (VIP) address on S-Series router Is it possible to build a cluster using different model# in Wing5? How to configure Layer 3 inteface on S-Series DHCP Clients sending DHCPDECLINE packets How To Configure VLAN trunk on S-Series Where do I add NAC IA-ES-3K and IA-PA-3K licenses Secure Stack Switch will not power up SIEM hard drive failure E1810 MAC Addresses Being Learned On Underlying Ports

Wednesday June 10:
NAC: Restricting access for nondomain devices
Poor WiFi performance with Lenovo Yoga 13
S-Series SNMP MIB Walk Runs Slow when encountering TimeFiltered OIDs
rtmgr process crashes when next-hop interface for default route learned via BGP goes down
Does EXOS have a feature similar to Cisco's ASA IP SLA?
How To Configure VRRP on S-Series and Securestack
SecureStack A, B & C Series. will not boot up, reset/crash none stop.
S-Series: Error message logged - <3>Dune[6.dTcmTask]Petra[0] Received Interrupt B_IQM_ECC_INTR_ERR instance 0, count 4, value= 0x1
Switch fabric channel has been disabled due to failed connection
IOM module failed to recover
Kernel oops: ERROR: Assertion failed: (block >= 0)
Why are there no clients in Purview reports for application response times
How many times can a trial license be extended

Tuesday June 9:
ARP consumed on the VRRP Standby where it has a Master instance with same VRID
How to Show MAC Address to Port Mapping in 800 Series Switch Using CLI
HP E5406 Configuration used for NAC authentication
Issues with XGM3 module
DOT1P value for the CPU generated packets in Summit switches
How to Deploy a Hyper-v NAC or NetSight VM
BASE-T SFP does not become active after reboot
How to obtain the serial number on a Purview sensor appliance.

Monday June 8:
is ntp.xmod mandatory to enable NTP server ?

3 replies

Userlevel 6
Nice! Thanks Ken.
Userlevel 7
Looks like I can't "like" the post so here a +1like for you.
Looks like I can't "like" the post so here a +1like for you.
I changed the post type - liking is possible now 🙂