Header Only - DO NOT REMOVE - Extreme Networks

Upgrade Matrix N 5.35.16 to new release 7.63.05.0002


I have enterasys Matrix N3, right now it´s running the release version 5.35.16, I need to update to 7.63.05.0002, Can I update the router directly, without update to a other middle releaser like 6?

8 replies

Userlevel 5
Hello Luis,

6.1 firmware 'window' upgrade is required.

Always recommended before upgrade of any kind: begin by saving a backup of your config file in case config translation fails.

You will want to carefully review the 6.1.x release notes and the 7.63.x release notes as there are several other caveats.

Regards,
Mike
Thanks Mike I will do !
Userlevel 5
Luis,

Based on lab experience - you can indeed upgrade from 5.x to 7.x provided hardware requirements are met - as long as you are prepared to re-configure from scratch.

The step-up method allows for a degree of config translation.

Mike
Userlevel 4
As Mike says you will need to go via version 6. As well as the release notes the following document details all the important points to consider when transitioning from 6.x to 7.x :

https://extranet.extremenetworks.com/downloads/Pages/dms.ashx?download=ca673e07-1e70-4997-9d18-66e71...

most important being :

- N‐Series modules must each have a minimum of 256MB of memory installed.Use the show system utilization storage command to determine the memory installed in each slot of your release 6.x system.

- N-Series firmware releases 7.11.x and greater utilize a new internal "binary" format for storing configurations. Versions 7.11.01.0025 or newer firmware will clear an internal configuration that was written in the older format. To avoid loss of configuration during an upgrade you must take specific steps to create and restore an ASCII configuration file. They are detailed in the document.

Best Regards
Glyn
Thanks guys, I have other question, the N3 and N5 right now are in End of Support?
Userlevel 3
Official End of Support is June 30, 2016.
Userlevel 3
George, Chris wrote:

Official End of Support is June 30, 2016.

Information regarding our End of Sales and End of Support products can be found here:
http://www.extremenetworks.com/support/end-of-sale-and-end-of-support-products
George, Chris wrote:

Official End of Support is June 30, 2016.

Thanks George!

Reply