Vlan tagged policy mappings on C3


Hello all! I am trying to set vlan mapping to policy on a trunk port of a C3. I did check port level mappings enable under the policy manager edit pulldown. I see no reference to this action in the config of the switch after I enforce. Is this possible with a C3 or did I miss a step or two?
thnks in advance
walt

1 reply

Userlevel 6
The Feature Support B3/C3/G3 section in the NetSight Policy Manager Firmware Support help section says Tagged Packet VLAN to Role Mapping is supported, but

On B3 and C3, this feature will not work properly unless the "Number of Users Allowed" attribute on a port is set to 2 or more. Supported on both device and port level, but only one mapping is allowed at the device level and on each port.

So maybe you need to set it at the device level too?

Reply