How do I make the Access Point only support 802.11ac or 802.11n. Is there a way to only support certain protocols without allowing things like 802.11a and 802.11b?
The only thing I see if what I provide. I don't see an "n-only" or an "n and ac" ...
I am trying to access the boot up status data that is shown on the serial port when you restart the access point. I am wondering if this data is captured somewhere and how to access it.
I can see this data on the serial port, but I don't know how ...
I am trying to shutdown the access point radio over SNMP.
I have an OID from the MIB that says I should be able to do this, but I cannot find a value that will be acceptable.
The OID 1.3.6.1.4.1.388.50.1.3.34.2.1.5 - wingCfgAltDevIfShutdown, is...
I am trying to set the radio transmission power level over SNMP.
I have an OID from the MIB that says I should be able to do this, but I cannot find a value that will be acceptable.
The OID 1.3.6.1.4.1.388.50.1.3.16.2.6.1.3 - wingCfgProfIfRadio...
I have a user who needs to see if there are any faults on the access point radios over SNMPv3. I have looked through the MIB OIDs, but I cannot find any sort of fault status provided for the radios of the access point. The only thing I can find is ...
Ok, so I have to support a basic rate of some kind. I think I am following. So if I want to limit 802.11a and 802.11g usage on my network.
I would set the following:
ap7532-15E560(config-device-84-24-8D-15-E5-60-if-radio1)#data-rates custom basi...
So I am still not clear if I can only support 802.11n and AC only, I am going to say the answer is no. I don't want to support 802.11b clients, they are two slow and not wanted on my network, so I will not allow them to connect. The same is true of...
Right, but the problem is I cannot just support 802.11n and AC. I have to support more than that.
MCS-4s is 802.11a/g and only part of 802.11ac. How would I just support all of 802.11n and AC?
MSC0-7 is everything. I am not clear how do just...
