Extreme Networks

Paulo_Pereira · 07-02-2015

Hello everyone. I Recently got a B2G124-48 switch. When trying to access it through the console interface, nothing happens. I can not get any feedback from the console, even after performing the admin password reset procedure. Apparently, this swi...

Paulo_Pereira · 07-13-2015

Hi, ok, as there was a strong suspicion of failure/damage, I decided to open the unit and investigate. After a while I found the problem. Was the small flat cable that connects the board to the external console plug. After replacing the flat cable...

Paulo_Pereira · 07-09-2015

Hello everyone, I apologize for the delay, but I've been a little busy. That was the first things I checked, the pin-out (Only three pins, 2, 3 and 5, which correspond respectively to the RX, TX, and GND), the cable and the connection setti...

Paulo_Pereira · 07-03-2015

Hi there, Once again, thank you all for your reply's. Well, this unit was a stack member and was removed from it due to infrastructure upgrade. He keeps the settings it had when it was in the stack. My company gave me the equipment, but now I...

Paulo_Pereira · 07-02-2015

Hi, and thanks for the reply I already tried this procedure, but does not work, nothing appears on the console terminal. The terminal e correctly configured and the cable is working fine.

Extreme Networks

User Statistics

User Activity

Factory reset B2G124-48 without console access

RE: Factory reset B2G124-48 without console access

RE: Factory reset B2G124-48 without console access

RE: Factory reset B2G124-48 without console access

RE: Factory reset B2G124-48 without console access