Hello, I'm needing some help setting up a layer 2 vpn between two X460-24t across a wan. I have all the necessary licensing and feature packs installed. The wan used static routing and is 3 hops away, also the routers in between do not participate in...
I looking for some configuration examples of using L2PT. I have 2 X460 w/Core licensing at different locations. I would like to create a layer 2 tunnel between this two switches over a MPLS circuit. Basically extending a layer 2 VLAN in to two locati...
Does any one know what causes the following errors?
06/18/2015 14:27:51.78 Slot-2: Error reading from XEN card eeprom (1, 83)
06/18/2015 14:12:22.98 Slot-1: Error reading from XEN card eeprom (1, 83)
The errors was reported on a stacking switch run...
I've found the answer... Yes when I add the VMAN to the ESRP doman it block the ports on the slave router.
#
# Module esrp configuration.
#
create esrp LDC
configure esrp LDC domain-id 25455
configure esrp LDC priority 100
configure esrp LDC add mas...
Prashanth, I wonted to add that was checking the advertising of each of the routers. I'm seeing a diffrence on the two routes.
snj-xm0-nsw010.8 # sh mpls ldp label advertised
Advertised Destination Label Peer NHop
Label Mapp...
Hi Prashanth, yes there is routers in between there are X450a with only Advanced Edge licening so I can't enable MPLS. I would think that the X450a would pass the MPLS traffic? Is there something that would stop them from doing so?
Thanks again, Mat...
