Header Only - DO NOT REMOVE - Extreme Networks

switch priority


How to check the switch priority on enterasys switch stack ?

4 replies

Userlevel 2
Ali,
The relevant commands should be something like
show switch
or
show switch [u]
or
show config switch
this will show you the priority assignments of the switch stack.
Userlevel 4
You might find this document to be helpful as well:
Thanks for your replies but what i am looking for switch priority number like in CISCO switch we have a priority column for the stack. Just look below the exhibit. i am not able to find that thing in Enterasys

3750-Stk>show switch Current Switch# Role Mac Address Priority State -------------------------------------------------------- 1 Slave 0016.4748.dc80 5 Ready *2 Master 0016.9d59.db00 1 Ready[/code]
Userlevel 4
The stack priority is unfortunately not one of the fields displayed in the tabular output of a '
code:

show switch

' command:C5(su)->show switch
Management Preconfig Plugged-in Switch Code
Switch Status Model ID Model ID Status Version
------ ------------ ---------- ----------- ------------ -------------
1 Mgmt Switch C5K125-48 C5K125-48 OK 06.71.04.0004
2 Unassigned C5K175-24 Not Present 00.00.00
C5(su)->[/code]It's only available in the output of a '
code:

show switch

<[code]unit#[/code]>' command, for the given switch unit. If its '
code:

Admin Management Preference

' reads as "
code:

Unassigned

", then the priority value is
code:

0

.

Reply