topic Re: Some APs does not accept radio profile in Aerohive Migrated Content

Some APs does not accept radio profile

michal_dolejsi — Tue, 24 Mar 2020 19:29:19 GMT

Hi community,

I discovered starange behavior with AP305C and AP510C/AP650 as well. I have radio-profile for these AP families. Some devices are configured with my own radio profile and some not. All devices are in the same location, same network policy. I can see at the device level that AP should use my radio profile, but if I check radio profile config through CLI or Config Audit, I can see the default one.

Device level:

Device Template:

Reality from CLI:

adio profile radio_ng_11ax-5g

radio profile radio_ng_11ax-5g phymode 11ax-5g

radio profile radio_ng_11ax-5g acsp access channel-auto-select time-range 01:00 04:00 station 0

radio profile radio_ng_11ax-5g acsp max-tx-power 20

...

What I am doing wrong? Suggestions? I have another AP510/650, which is configured properly ...

Re: Some APs does not accept radio profile

reinhardg — Wed, 25 Mar 2020 16:38:13 GMT

I'd reset one of these APs to factory defaults and deploy the config again.

Re: Some APs does not accept radio profile

ashley_finch — Wed, 25 Mar 2020 17:15:07 GMT

It may be running device level config instead of template/policy config. You may be able to do the following: From the manage device tab > tick the AP > actions > reset device to template defaults

Push the config either through delta or a complete. Does the AP then have the correct RP?

Re: Some APs does not accept radio profile

michal_dolejsi — Thu, 26 Mar 2020 14:02:14 GMT

Thanks Ashley, this solved my problem.