topic Re: Can't update policies on AP130: stuck on "Certification updating" in Aerohive Migrated Content

Can't update policies on AP130: stuck on "Certification updating"

ccarpio — Wed, 02 Sep 2020 16:47:34 GMT

Hello everybody!

I’m a teacher, not an IT expert and I have inherited an Aerohive setup, so please forgive me if I use any wrong terms.

I’ve been trying to update one policy for 7 of our AP (all of them are 130) for the past two days but I’m unable to do that.

They work properly, but I wanted to add another SSID to the policy. When I try to update the policy (it doesn’t matter if I go from Policy → Deploy update or directly from the device), it gets stuck for a while showing “Certification update” and a percentage that never changes. Sometimes it’s 3% and sometimes it’s 14%, but it doesn’t move.

After a while I get a “Device update failed” message

Re: Can't update policies on AP130: stuck on "Certification updating"

ccarpio — Thu, 03 Sep 2020 01:09:33 GMT

Here’s a screenshot showing where it gets stuck.

Re: Can't update policies on AP130: stuck on "Certification updating"

SamPirok — Thu, 03 Sep 2020 21:14:49 GMT

Hello, could you click on the device update failed message and let us know the details of the failure message? That should give us some clues as to why the update is failing. Also you might want to try upgrading your firmware to the latest version. Not only will that rule out any bugs that have been fixed in later versions, but if you can update the firmware and not the configuration, that will give us some more clues as to what is going on with the configuration update.

Re: Can't update policies on AP130: stuck on "Certification updating"

Ash_Finch — Fri, 04 Sep 2020 16:23:22 GMT

If it’s failing at the certification update, 9 times out of 10 it’s the firewall blocking the update in my experience.

I suspect if you try updating the firmware only, not config it will fail also.

Re: Can't update policies on AP130: stuck on "Certification updating"

aparadissis — Tue, 25 Jul 2023 20:40:49 GMT

Was there ever a solution for this? I clicked on the failure message, but the AP is not listed in the logs.