topic Re: DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting in Aerohive Migrated Content

DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

AnonymousM — Thu, 30 May 2019 18:05:54 GMT

DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

Re: DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

samantha_lynn — Thu, 30 May 2019 20:00:47 GMT

Could you tell me what firmware the 121, 230, and 250 are currently using?

Re: DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

AnonymousM — Mon, 03 Jun 2019 16:09:00 GMT

Hi,

Find below firmware details for respective AP models.

AP121
Version: HiveOS 6.5r11 build-216370

AP230
Version: HiveOS 6.5r11 build-216370

AP250
Version: HiveOS 8.2r4 build-207023

Regards,

Ramesh Pandey
Network Engineering
Group IS

Tel: +91 124 384 7390 Mob +91 9311084708

Atkins, member of the SNC-Lavalin Group
19th Floor, DLF Cyber Greens, DLF Cyber City, Gurgaon, Haryana - 122 002 INDIA

Re: DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

AnonymousM — Tue, 04 Jun 2019 19:40:14 GMT

any update ?

Re: DFS static-channel restore = disabled/enabled , not getting this in AP121 and AP230. However in AP250 its available. Is this specific hardware feature ? or external setting

samantha_lynn — Wed, 19 Jun 2019 19:21:55 GMT

Thank you for your patience while I looked in to this for you. We've tested this in our lab, and the 230 and 250 were able to use the command without issue. I had some trouble with the 121, but the 121 is not certified for DFS. This is stated in the HiveManager, in the Radio Profile section for Dynamic Frequency Selection:

That said, I was able to enable DFS on the 5GHz radio with the CLI command using an AP121 on 6.5r12. If you go this route, you'd want to create a supplemental CLI to keep the command on the AP.