topic Does anyone know how to bond eth0 and eth1 as one on the ap250 in Aerohive Migrated Content

Does anyone know how to bond eth0 and eth1 as one on the ap250

vdo — Fri, 04 Jan 2019 05:25:24 GMT

We have the ap 250 and you can use 2 network cables 1 on eth0 and 1 on eth1 we like to bond them so that they use 1 IP-adres does someone know how?

thank you in advance

Re: Does anyone know how to bond eth0 and eth1 as one on the ap250

samantha_lynn — Fri, 04 Jan 2019 05:47:34 GMT

It's almost physically impossible for the AP to exceed the 1gig Ethernet line max, so aggregating the ports doesn't have a lot of practical value. However, to do this, you would want to go in to Configure> Open the network policy> Go to Device Templates tab> Open the device template in use or create a new one> Select both Eth ports and Click Assign> Advanced Actions> Aggregate. You should now see an aggregate port in the "Wired Interfaces" section at the bottom of the template.

Re: Does anyone know how to bond eth0 and eth1 as one on the ap250

vdo — Fri, 04 Jan 2019 05:53:27 GMT

Okay Thank you for your answer I’ll look into it tomorrow.

Re: Does anyone know how to bond eth0 and eth1 as one on the ap250

jpye — Wed, 10 Jul 2019 02:18:00 GMT

When you connect these ports to a 2-port etherchannel on the switch (trunk ports) what port type do you specify on the ap250? Uplink or trunk?

Re: Does anyone know how to bond eth0 and eth1 as one on the ap250

samantha_lynn — Wed, 10 Jul 2019 02:51:43 GMT

You'd want to configure trunk ports if you've got more than one VLAN going through.