topic Re: Allow snmp on eth0 in Aerohive Migrated Content

Allow snmp on eth0

patkszen — Wed, 04 Sep 2019 21:00:09 GMT

I'm trying to allow snmp on AP130's. I know the command but I'm not sure how to configure it via hive manager classic 8.1r2

In other words I'm looking for hive manger setting that is equivalant to interface eth0 manage snmp command

Thanks

Re: Allow snmp on eth0

samantha_lynn — Thu, 05 Sep 2019 01:54:19 GMT

You should be able to configure that by going to Configuration> Opening the Network Profile> Edit Additional Settings within the Network Profile> Expand Management Server Settings> Edit or create a SNMP Server object and configure that how you'd like. You'll also want to go to Traffic Filter Settings in the Additional Settings of the Network Policy and enable SNMP either only for eth0 or for all of the interfaces at once.

Re: Allow snmp on eth0

patkszen — Thu, 05 Sep 2019 15:09:48 GMT

Hi Sam

I still can't see where you set which interface is to be enabled for snmp

Re: Allow snmp on eth0

patkszen — Thu, 05 Sep 2019 15:41:14 GMT

OK I've found it but it doesn't seem to be doing what I set it for

Guest traffic filter allows SNMP.

I was expecting this on AP to which I pushed the config:

show run | i snmp

....

interface eth0 manage snmp

....

But instead I got this:

show run | i snmp

....

ssid B_ssid manage snmp

ssid A_ssid manage snmp

....

Am I missing something here ?

Re: Allow snmp on eth0

samantha_lynn — Thu, 12 Sep 2019 02:00:06 GMT

Can you confirm that the SNMP settings were enabled in the Management Server settings as well? Without both parts we won't see that command in the running configuration.