https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71820#M5204 I have the AP650 access point. Im using both wired ports and they are set to uplink. However Im only getting 1 link light back on the switch. I have Dell N2000 switches. What do I have to do to make it use both wired ports? Thu, 23 May 2019 09:39:29 GMT donnie_johnson 2019-05-23T09:39:29Z https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71820#M5204 I have the AP650 access point. Im using both wired ports and they are set to uplink. However Im only getting 1 link light back on the switch. I have Dell N2000 switches. What do I have to do to make it use both wired ports? Thu, 23 May 2019 09:39:29 GMT https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71820#M5204 donnie_johnson 2019-05-23T09:39:29Z https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71821#M5205 <P>Aerohive APs use Kalpana style etherchannel to bond the two interfaces as one. First, you'll need to create a new template for the AP650s in your network policy. Name the template, eg AP650_etherchannel. Select the ETH0 and ETH1 interfaces, click the Assign button, select Advanced Actions and Aggregate. If you scroll down, you'll see a new interface, agg0. This is your Etherchannel interface. Save the template and assign clarification rules based upon Device Location, Cloud Config Group, IP address, Subnet or Range. </P><P>I've not used Dell switches, but it appears they call etherchannel Static Port-Channels and it appears to be very similar to Cisco's configuration. Here's a link...</P><P>https://www.dell.com/support/article/us/en/04/how10784/how-to-configure-a-static-port-channel-on-an-n-series-switch?lang=en</P><P>&nbsp;</P><P>Before you plug in both interfaces and cause loops and storms, make sure your etherchannels are configured an working with a single connected interface first.</P><P>Good luck! </P> Thu, 23 May 2019 14:04:42 GMT https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71821#M5205 bruce_stahlin 2019-05-23T14:04:42Z https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71822#M5206 <P>Thanks!</P> Thu, 23 May 2019 19:33:45 GMT https://community.extremenetworks.com/t5/aerohive-migrated-content/i-have-the-ap650-access-point-im-using-both-wired-ports-and-they/m-p/71822#M5206 donnie_johnson 2019-05-23T19:33:45Z