How do I change the Severity of my syslog messages on a Hive Switch through the CLI?

sbarnabas — Tue, 12 Feb 2019 02:36:27 GMT

Here is the output of 'show logging host'

Index IP Address/Hostname Severity Port Status Mode Auth Cert#

----- --------------------- ---------- ------ --------- ----- -------- -----

1 10.2.2.100 critical 514 Active udp

How do I change the Severity to Info using the CLI?

Re: How do I change the Severity of my syslog messages on a Hive Switch through the CLI?

samantha_lynn — Tue, 12 Feb 2019 05:07:37 GMT

The command to change that should be "logging server <syslogIP> level <level>". The level options are:

emergency Send emergency-level log entries

alert Send log entries from alert to emergency levels

critical Send log entries from critical to emergency levels

error Send log entries from error to emergency levels

warning Send log entries from warning to emergency levels

notification Send log entries from notification to emergency levels

info Send log entries from info to emergency levels

debug Send log entries for all severity levels

So for example, if the syslog server IP address was 10.2.2.100, and you wanted to set it to info level, the command would be "logging server 10.2.2.100 level info".

topic Re: How do I change the Severity of my syslog messages on a Hive Switch through the CLI? in Aerohive Migrated Content

How do I change the Severity of my syslog messages on a Hive Switch through the CLI?

Re: How do I change the Severity of my syslog messages on a Hive Switch through the CLI?