topic Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically. in Aerohive Migrated Content

I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

jneil — Wed, 06 Mar 2019 06:03:43 GMT

I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

samantha_lynn — Wed, 06 Mar 2019 20:43:03 GMT

Could you go in to the device specific settings for the Master Switch by going to Monitor and clicking on the host name of the device, and confirm that a network policy is applied in the Device Configuration settings?

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

jneil — Wed, 06 Mar 2019 23:52:07 GMT

The network policy for the switch stack is listed as “no change”. In the onboarding settings I selected the network policy I would like to have pushed.

I have repeated the process a few times.

Jeffrey Neil
Network Engineer
KinderCare Education LLC
jneil@kindercare.com
W: 503-872-3168

[cid:image004.jpg@01D2085C.2C7E64E0]
NOTICE: This email may contain privileged or other confidential information. If you’ve received it in error, please advise the sender by reply email and immediately delete the message and any attachments without copying it or disclosing its contents to others. Thank you.

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

samantha_lynn — Thu, 07 Mar 2019 03:57:39 GMT

You should only see "no change" if we're viewing multiple devices at once. Could we look at only the Master switch device configuration settings?

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

jneil — Thu, 07 Mar 2019 05:14:32 GMT

It is showing “no change” for the policy and the template after the onboard process. I can manual add the policy under “stack configuration” after which it shows the name of the policy but the device template is still “no change”.

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

samantha_lynn — Thu, 07 Mar 2019 05:26:36 GMT

I think you might want to open a case for this issue so our technicians can start gathering data with you. I'm not sure why you would be seeing no change if we were only viewing one switch at a time and we'll need to look in to that.

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

jneil — Thu, 07 Mar 2019 05:38:39 GMT

Jeffrey Neil
Network Engineer
KinderCare Education LLC
jneil@kindercare.com
W: 503-872-3168

[cid:image004.jpg@01D2085C.2C7E64E0]
NOTICE: This email may contain privileged or other confidential information. If you’ve received it in error, please advise the sender by reply email and immediately delete the message and any attachments without copying it or disclosing its contents to others. Thank you.

Re: I am adding a switch stack to Aerohive and the onboarding process is not pushing the network policy automatically.

jneil — Thu, 07 Mar 2019 05:40:47 GMT

The switches are in a stacked configuration and I am unable to look at either one by itself. They show up in the Hive Manager as a “SR2300-Series-Stack -(2)<>”.