https://community.extremenetworks.com/t5/data-center-slx/mlxe-rbridge-vs-vrid/m-p/19726#M1 I am working on configuring VRRP instances in a pair of MLXe routers. <I>Can the Rbridge ID and the VRID be the same value?</I> I was told they could not but our config shows otherwise. <BR /> <BR /> Also, after poking around "the Hub" it appears that I can use the same VRID for all VLANs that will be used in both MLXe routers. Is this good practice or just convenience? <BR /> <BR /> Thank you.<BR /> Wed, 27 Jun 2018 02:05:00 GMT Will_Irizarry 2018-06-27T02:05:00Z https://community.extremenetworks.com/t5/data-center-slx/mlxe-rbridge-vs-vrid/m-p/19726#M1 I am working on configuring VRRP instances in a pair of MLXe routers. <I>Can the Rbridge ID and the VRID be the same value?</I> I was told they could not but our config shows otherwise. <BR /> <BR /> Also, after poking around "the Hub" it appears that I can use the same VRID for all VLANs that will be used in both MLXe routers. Is this good practice or just convenience? <BR /> <BR /> Thank you.<BR /> Wed, 27 Jun 2018 02:05:00 GMT https://community.extremenetworks.com/t5/data-center-slx/mlxe-rbridge-vs-vrid/m-p/19726#M1 Will_Irizarry 2018-06-27T02:05:00Z https://community.extremenetworks.com/t5/data-center-slx/mlxe-rbridge-vs-vrid/m-p/19727#M2 Hi,<BR /> <BR /> When using MCT the cluster rbridge-id must be unique on each device.<BR /> <BR /> With respect to VRRP(e) VRID as you mention the same VRID can be used in each instance running in their own VLAN.<BR /> <BR /> I have seen this done both ways many times, some just set VRID as 1 in every VLAN which is valid and works fine. Others vary the VRID for each VLAN but obviously there is only 1 to 255 available.<BR /> <BR /> It simply comes down to what works best for you there is not a hard and fast rule for this.<BR /> Fri, 29 Jun 2018 12:52:00 GMT https://community.extremenetworks.com/t5/data-center-slx/mlxe-rbridge-vs-vrid/m-p/19727#M2 Mick_Day 2018-06-29T12:52:00Z