topic NOS - selection of port range - possible? in Data Center (SLX)

NOS - selection of port range - possible?

Pawel_Eljasz — Mon, 11 Mar 2019 18:47:26 GMT

hi everyone,
Other vendors, Dell I use, give you an option to commands where a selection of ports can be made, specified and then you can operate/configure all those ports in the range.
Is it possible with NOS?
many thanks, P.

Re: NOS - selection of port range - possible?

Sargis_Minasyan — Mon, 11 Mar 2019 19:17:07 GMT

Hi Pawel,

Yes, you can use the below option:

code:

rb2(config)# int te 2/0/1-10
rb2(conf-if-te-2/0/1-10)#

Many thanks,
Sargis

Re: NOS - selection of port range - possible?

Pawel_Eljasz — Mon, 11 Mar 2019 20:59:10 GMT

Good. And non-continuous and multiple ranges?

Re: NOS - selection of port range - possible?

Sargis_Minasyan — Mon, 11 Mar 2019 21:11:40 GMT

as long as you are selecting ranges of ports on a single VDX/linecard, you can do commas:

code:

rb3(config)# int te 2/0/1-10,13-20,23-33
rb3(conf-if-te-2/0/1-10,13-20,23-33)#

I don't think you can do ranges across VDXes or linecards.

Many thanks,
Sargis

Re: NOS - selection of port range - possible?

Pawel_Eljasz — Tue, 12 Mar 2019 01:34:48 GMT

Ah, that was what I started with, 1/x/x,2/x/x. It did not work, I assumed nothing worked, but then I thought.. nehh. I better ask.
p.s. this should go into manual docs.