topic CLI COMMANDS PERMANENT in ExtremeCloud IQ

CLI COMMANDS PERMANENT

mannix — Sun, 02 Jul 2023 01:50:00 GMT

Hello !

I've been changing some options with the CLI commands, but every time I reboot or update it goes back to default settings... sorry the ignorance, but is ther a way to make the CLI command changes permanent?

Thx!

Re: CLI COMMANDS PERMANENT

mannix — Sun, 02 Jul 2023 14:12:30 GMT

Found it!

save config...

Re: CLI COMMANDS PERMANENT

jlmangas — Mon, 03 Jul 2023 07:15:43 GMT

Hello,

No, that's not the solution.

An update will revert your cli commands back. To make them permanent you have to use Supplemental CLI thru the XIQ Web interface, either at Policy level, AP template level or Device level. In any case, you have to activate Supplemental CLI in the Global Settings -> VIQ Management.

Re: CLI COMMANDS PERMANENT

Jan_Reister — Mon, 03 Jul 2023 07:35:54 GMT

A Supplemental CLI would add your CLI commands to the AP profile and have it survive firmware upgrades, factory default resets and other events.

Re: CLI COMMANDS PERMANENT

bswaby — Wed, 05 Jul 2023 14:11:28 GMT

Mannix, are you looking at doing all CLI management on your devices? We have around 95 devices and got the dreaded message today of the 10-device limit coming soon. ;(. I hate that as Aerohive/Extreme has been our go-to for most of our churches and might need to consider switching.

Are you doing mass CLI management or just a couple?

Trying to figure out what tools to consider pending what our sales agent from Extreme comes back with. If anything it can get us temporarily by until we determine the next steps.