topic Re: AP650 160mhz in ExtremeCloud IQ

AP650 160mhz

felixhuynh27 — Sat, 19 Aug 2023 07:22:56 GMT

I just purchased 4 AP650 and controlled them with Extreme cloud connect mix with CLI to individual AP. My current problem is similar to one of this old post:

https://community.extremenetworks.com/t5/aerohive-migrated-content/aerohive-ap650-11ax-ap-the-product-spec-sheet-said-160mhz-but/m-p/86856

On cloud webGUI I can only choose up to 80mhz for channel width. As for cli to individual AP, running command <radio profile [radio name] channel-width 160 doesn't seem to change the config as I check with <show interface> and <show interface wifi1> the channel width still remains at 80mhz. Much appreciated for helps.

Re: AP650 160mhz

victormarcel — Tue, 22 Aug 2023 03:56:23 GMT

Ensure that the firmware or software version you're using supports the desired channel width. Sometimes, limitations in the software or hardware might prevent certain configurations.

TellPopeyes.com

Re: AP650 160mhz

felixhuynh27 — Mon, 21 Aug 2023 12:24:27 GMT

My ap model is AP650AH which I read the datasheet should have 160mhz. My current firmware is 10.6

Re: AP650 160mhz

Christoph_S — Mon, 21 Aug 2023 21:29:47 GMT

Hello Felix,

It's not recommended to enable 160MHz channel width on the 5GHz radio since this will leave you with only 2 channels to to select from. On the WiFI 6 APs this can only be activated via CLI. No 160MHz channel width GUI settings for the 5GHz APs. On the other hand the 6GHz WIF6E APs will have this available in GUI since enough channels are available to justify enabling it.

Here's an article for your perusal: https://extremeportal.force.com/ExtrArticleDetail?an=000097122

I hope this helps,

BR,