topic Re: ECC Internal Accept Only Captive Portal in ExtremeCloud IQ Controller

ECC Internal Accept Only Captive Portal

Bob_Reinert — Thu, 31 Dec 2020 22:56:58 GMT

Trying to setup an internal captive portal on ECC with an accept only policy. I get the splash page and click accept policy and register. It says I registered, but I’m not able to get out to the network after successful registration. The initial auth role is unregistered.

Re: ECC Internal Accept Only Captive Portal

Miguel-Angel_RO — Thu, 31 Dec 2020 23:43:42 GMT

Hi breinert,

Please share a screenshot with the authenticated client info from the monitoring section and a screenshot of the rules tab from the configuration section.

Mig

Re: ECC Internal Accept Only Captive Portal

Bob_Reinert — Fri, 01 Jan 2021 00:34:29 GMT

Re: ECC Internal Accept Only Captive Portal

Bob_Reinert — Fri, 01 Jan 2021 00:35:06 GMT

I had to send in two replies in order for them to send.

Re: ECC Internal Accept Only Captive Portal

Ovais_Qayyum — Fri, 01 Jan 2021 00:53:04 GMT

Hi breinert,

I would add to Mig’s response. I don’t see you getting the default “Guest Acess” role after successful registration, it shows some weird role name under client details. Did you make any change to the default Guest Access rule in the rule engine? when you create a Guest SSID a default Guest Access rule is automatically created in the rule engine, upon successful authentication this rule will assign the client to the Guest Access role.

couple of things you can check:

1- Make sure the role you want to assign after successful authentication is applied to the AP profile, you can check that by navigating to the Device groups > Profile > Roles.

2- Send the screenshot of XCC Rules Engine.

Regards,
Ovais

Re: ECC Internal Accept Only Captive Portal

Bob_Reinert — Fri, 01 Jan 2021 01:28:26 GMT

Appreciate the assistance in pointing out the role assigned. I deleted that config and created new portal and WLAN and it seems to work.