https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41007#M5144 Could you post a screenshot of the CLI ouput so we'd have a better unterstanding of the issue. Fri, 22 Jun 2018 23:26:00 GMT Ronald_Dvorak 2018-06-22T23:26:00Z https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41006#M5143 We are attempting to create authentication by 802.1x send devices to several contain to vlan policies; we are not sure why there are multiple entries for the same vlan after adding the new vlans to the switches. We were told by the Extreme tech to run "set vlan create ##" on each switch - I don't know if that caused the multiple entries or if I did something else wrong.<BR /> Fri, 22 Jun 2018 23:09:00 GMT https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41006#M5143 Seth_Bean 2018-06-22T23:09:00Z https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41007#M5144 Could you post a screenshot of the CLI ouput so we'd have a better unterstanding of the issue. Fri, 22 Jun 2018 23:26:00 GMT https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41007#M5144 Ronald_Dvorak 2018-06-22T23:26:00Z https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41008#M5145 This is found in the GUI of Policy Manager, not CLI. I created the VLANs on each switch, but upon some research I believe I was given bad advise and should have added the VLANs via the Primary VLAN Model in VLAN Elements Editor.<BR /> Sat, 23 Jun 2018 00:12:00 GMT https://community.extremenetworks.com/t5/extremecloud-iq-site-engine/multiple-entries-for-same-vlan-in-policy-manager/m-p/41008#M5145 Seth_Bean 2018-06-23T00:12:00Z