How can I over Netsight through the events of Syslog or Traps

Jairo_Rojas_Her — Wed, 15 Feb 2017 04:48:00 GMT

How can I in Netsight through the events of Syslog or Traps bring me the following data of the switch or Access Point?

SysName:
SysLocation:
SysContact:
System MAC:
System Type:
SysHealth check:
Recovery Mode:
System Watchdog:
Current Time:
Timezone:
Boot Time:
Boot Count:
Next Reboot:
System UpTime:
Slot-1:
Slot-2:
Slot-3:
Slot-4:
Slot-5:
Slot-6:
Slot-7:
Slot-8:

To generate the alarms through mail, I use the following fields:
Location: $ sysLocation
IP Address: $ deviceIP
SW Name: $ sysName
Date / Time: $ time
Message: $ message

Additional data
Model Team: $ chassisType
AlarmSource: $ alarmSource
Subcomponent: $ alarmSubcomponent
Event Details: $ eventTitle
Severity: $ eventSeverity
Category: $ eventCategory
Firmware Version: $ deviceFirmware
Device Status: $ deviceStatus

RE: How can I over Netsight through the events of Syslog or Traps

Ty_Izzet — Sat, 18 Feb 2017 05:56:00 GMT

Jario, I am not sure I fully understand the question. But is it possible that some of the variables may be missing from the alarm configured? If that is the case then please review the following article:

https://gtacknowledge.extremenetworks.com/articles/Solution/Alarm-Manager-notification-sends-E-Mail-...

topic RE: How can I over Netsight through the events of Syslog or Traps in ExtremeCloud IQ- Site Engine Management Center

How can I over Netsight through the events of Syslog or Traps

RE: How can I over Netsight through the events of Syslog or Traps