topic SNMP Contact Lost / cant able to "configure" or "show" SNMP ? in ExtremeCloud IQ- Site Engine Management Center

SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Boopaa — Thu, 13 Oct 2016 16:48:00 GMT

Cant able to view or configure the SNMPv3 in my 8810-BD, getting triggers from netsight " SNMP contact lost" & cant able to configure or unconfigure the SNMP??????

Need support to fix this SNMP issue !!!!!!

Can any one help me in this.!!!!!

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

AG1 — Thu, 13 Oct 2016 17:13:00 GMT

Hello Boopathy:

I have put together few articles that I believe will help you to get started with SNMPv3 configuration on EXOS based switches:

Setup SNMPv3 on EXOS

How to get XOS SNMPv3 settings to work with default Netsight SNMPv3 Credentials

New switch shows SNMPv3 contact lost in NetSight with Authentication Failure

I hope it helps.

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Boopaa — Thu, 13 Oct 2016 19:00:00 GMT

Thanks for your response..!!!

I have tried this articles but the issue is different..!!!
"show config snmp" itself not working and also i cant able configure or unconfigure the SNMP..???

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

AG1 — Thu, 13 Oct 2016 19:19:00 GMT

Would you mind sharing the output printed by the switch after issuing each of the command lines you have mentioned above?

What version of EXOS is the switch running?

Thank you.

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Boopaa — Thu, 13 Oct 2016 19:31:00 GMT

currently its running on EXOS 15.6.4.2 patch 1-3.

When I press the TAB after tying " configure snmpv3" its showing " invalid command"

Even If i Press " Configure ? " i could not able to see "snmp" in that list.

I think the SNMP has crashed...???

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Ron_Huygens — Fri, 14 Oct 2016 13:48:00 GMT

You can check the status with the command:
sh process | incl snmp

* X450a-48t.6 # sh process | incl snmp
snmpMaster 3.0.0.2 0 Stopped Wed Sep 28 06:34:26 2016
snmpSubagent 3.0.0.2 0 Ready Wed Sep 28 06:34:26 2016

Both processes should be "ready"

If one or both are "stopped" you can start them with
start process "snmpMaster"

https://gtacknowledge.extremenetworks.com/articles/Q_A/How-do-I-restart-the-snmp-process-there-is-sn...

RE: SNMP Contact Lost / cant able to "configure" or "show" SNMP ?

Boopaa — Fri, 14 Oct 2016 14:38:00 GMT

Thank you so much Huygens..!!!
Its really superb..!!!

The Issue is fixed...!!!!!!!!

Currently SNMP is functioning properly..!!!!