topic RE: When using the SNMP default value in Netsight (from 6.3) : what are the CLI for XOS ? in ExtremeCloud IQ- Site Engine Management Center

When using the SNMP default value in Netsight (from 6.3) : what are the CLI for XOS ?

Pascal_Lurquin — Tue, 31 May 2016 20:17:00 GMT

CLI XOS to configure the default snmp access for Netsight I would like to add new switches ( X460, X440 ...) with XOS 16.X from the Netsight Console. But it's not so easy to do compare from the legacy Riegeline with snmpv3 ! What are the procedure to do this job quickly ? Thanks

RE: When using the SNMP default value in Netsight (from 6.3) : what are the CLI for XOS ?

Ty_Izzet — Tue, 31 May 2016 21:35:00 GMT

Pascal,

The default SNMPv3 credentials within EXOS are not included in the NetSight profiles. You can create them based on the current switch credentials, or use the following article to create a the user and group on the EXOS switch.

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-get-XOS-SNMPv3-settings-to-work-wit...

The default credentials on the switch are listed in the following article:

https://gtacknowledge.extremenetworks.com/articles/Q_A/What-default-SNMP-credentials-are-present-in-...

RE: When using the SNMP default value in Netsight (from 6.3) : what are the CLI for XOS ?

Kevin_Kim — Wed, 01 Jun 2016 13:26:00 GMT

Configure the SNMPv3 commands below in an EXOS switch and add this switch using 'snmp_v3_profile' in NetSight.

# configure snmpv3 add user snmpuser authentication md5 snmpauthcred privacy des snmpprivcred
# configure snmpv3 add group snmpgroup user snmpuser sec-model usm
# configure snmpv3 add access snmpgroup sec-level priv read-view defaultAdminView write-view defaultAdminView notify-view defaultNotifyView