topic EWC sends data to Purview. Wan router also see the data in ExtremeCloud IQ- Site Engine Management Center

EWC sends data to Purview. Wan router also see the data

JohanHendrikx — Fri, 06 Jul 2018 12:25:00 GMT

After configuring EWC to send data to PurView Analiticys an strange problem happend.

The data that the AP send to Purview was detected by our wan router and send the to opur intenal firewall.

For the firewall thsi is spoofing because the networks are on the internal side.

I made a trace on oure firewall and the data was on the WAN interface

How can this be resolved ?

RE: EWC sends data to Purview. Wan router also see the data

Mike_Thomas — Fri, 06 Jul 2018 16:08:00 GMT

Johan, is the Purview/Analytics appliance or the EWC across the WAN/FW from the other?

RE: EWC sends data to Purview. Wan router also see the data

JohanHendrikx — Fri, 06 Jul 2018 16:38:00 GMT

Yes the Purview/Analytics applicance and the EWC are across the WAN, The firewall is on the same location as the AP's

RE: EWC sends data to Purview. Wan router also see the data

Zdeněk_Pala — Sat, 07 Jul 2018 01:11:00 GMT

Hi. There are two ways how the EWC does talk to Analytics Engine (purview). Option 1 (old) there is netflow and FirstN mirror. Option 2 (newew) there is only IPFix I do not expect any issue with option 2 as IPFix is standard UDP traffic. With Option 1 you can have issues with firewall. Officially the option 1 does require direct connection between EWC and the engine. You should be very carefull with anything between EWC and Engine. Even switch between EWC and Engine can be tricky (raw mirrored frames are there). Regards Z.

RE: EWC sends data to Purview. Wan router also see the data

JohanHendrikx — Sat, 07 Jul 2018 01:11:00 GMT

is this the document you refers to: https://gtacknowledge.extremenetworks.com/articles/How_To/Configuring-a-Identifi-Wireless-Controller...

When I check the wlan I see that netflow is enable. that's oke ?

RE: EWC sends data to Purview. Wan router also see the data

Mike_Thomas — Sat, 07 Jul 2018 01:11:00 GMT

That article reflects method #1, Method #2 is configured directly via the XMC platform itself under configuration and then add it. See below.

RE: EWC sends data to Purview. Wan router also see the data

JohanHendrikx — Sat, 07 Jul 2018 01:11:00 GMT

But for data collection, I have to check the wlan's ?

RE: EWC sends data to Purview. Wan router also see the data

Mike_Thomas — Sat, 07 Jul 2018 01:11:00 GMT

Yes, It does need source WLAN or Ports as well. I omitted that for simplicity. You can add as few or as many as needed.

RE: EWC sends data to Purview. Wan router also see the data

JohanHendrikx — Sat, 07 Jul 2018 01:11:00 GMT

new configuration works. thanks